[Dx4win] HAL DXP38 with DX4WIN ?

Sat, 02 Feb 2002 18:02:34 -0500

Saad,

As far as I know, the HAL equipment does not support a terminal like
interface as most other TNC/RTTY devices do. It uses a special
control language that was never supported by DX4WIN. 

Paul

At 01:32 PM 2/2/02 -0600, SAAD MAHAINI wrote:
>Hello,
>
>I just switched my TTY setup from the AEA PK-232MBX/DSP to the HAL DXP38
>TNC.
>
>The old TNC worked fine with both AEA software and DX4WIN.
>
>The new TNC works fine with the HAL software that comes with it, but I just
>can't get it to work with DX4WIN.  I changed, confirmed, played with,
>reconfigured, and done anything I can, but it's a puzzle, and I can't get it
>going.  I hope I can get some help on this reflector.
>
>Is there anyone out there that is successfully using the DXP38 with DX4WIN
>
>73s Saad N5FF
>
>_______________________________________________
>Dx4win mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/dx4win 

~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Paul van der Eijk (KK4HD)
[email protected]
http://www.dx4win.com