[Dx4win] CW keyboard question

Tue, 3 Dec 2002 18:29:30 -0600

The radio does not use the same pins on Comm 1 as the cw output ..... hence
you can use com1  for both. I also believe the keying output also goes to
the parrallel port.
John K9DX
----- Original Message -----
From: "Pete Stafford" <[email protected]>
To: <[email protected]>; <[email protected]>
Sent: Tuesday, December 03, 2002 4:33 PM
Subject: RE: [Dx4win] CW keyboard question


> Nope.  The documentation for v5.03 refers as well to the same port as that
> set up for the radio.  Strange.
>
> Pete, K2PS
>
> -----Original Message-----
> From: Barry [mailto:[email protected]]
> Sent: Tuesday, December 03, 2002 4:41 PM
> To: [email protected]
> Subject: [Dx4win] CW keyboard question
>
>
> After using DX4WIN for almost 10 years, I just got the urge to try the
> CW keyboard for the first time. To my chagrin, I find there is no choice
> of serial ports - it only uses the same COM port as the radio. This is the
> case in my version 4.07. Do the newer versions of DX4WIN support
> COM port selection for CW keying?
> Tnx,
> Barry
>
> --
> Barry Kutner, W2UP              Internet: [email protected]
> Newtown, PA                     Frankford Radio Club
>
>
> _______________________________________________
> Dx4win mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dx4win
> _______________________________________________
> Dx4win mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dx4win
>