[Dx4win] Problems with XP Conversion
Pawel, SP7PS
[email protected]
Sat, 17 Aug 2002 21:25:39 -0000
Hello Duane,
I use version 5.03. After upgrade from Win 98 SE I had problem with DX4WIN
and only DX4WIN..... Other softwares, e.g. WriteLog, Logger, MMTTY,
ChromaPix worked right.... All the problems with DX4WIN ran away after full
install of WinXP Home Edition.
Best 73's
Pawel, SP7PS
----- Original Message -----
From: "Duane A Calvin" <[email protected]>
To: <[email protected]>
Sent: Saturday, August 17, 2002 5:26 PM
Subject: Re: [Dx4win] Problems with XP Conversion
> I assume what you're saying is true for DX4WIN 3.05 and not 5.03? I ran
> the upgrade version of WinXP Home and the CW keying worked fine on 5.03
> by either following the instructions to install the driver or by
> reinstalling DX4WIN 5.03. I can't speak to 3.05...
>
> 73, Duane
>
>
> On Sat, 17 Aug 2002 08:56:49 -0000 "Pawel, SP7PS" <[email protected]>
> writes:
> > Hello Stu,
> > I had exactly the same problem few months ago. You need to install
> > FULL
> > version of Windows XP, not upgrade.
> > See my post from 10th Jan 2002:
> >
> > "Thanks for all suggestions and help I got from you to solve the
> > problem
> > with
> > reading transceiver frequency under Windows XP.
> > After few days of trying to made work radio and DX4WIN (I installed
> > all XP
> > supported drivers, reinstalled DX4WIN, etc) I formatted hard drive
> > and
> > installed Windows XP again, but not as upgrade but full instalation.
> > It is
> > right now, all my programs work as they should.
> >
> > So, if you plan to install Windows XP my suggestion is do not make
> > upgrade
> > from previous operating system, but make new FULL instalation."
> >
> > Hope, it helps.
> >
> > Best 73's
> > Pawel, SP7PS
> >
> >
> >
> > ----- Original Message -----
> > From: "STU" <[email protected]>
> > To: "DX4WIN POSTINGS" <[email protected]>
> > Sent: Saturday, August 17, 2002 3:49 AM
> > Subject: [Dx4win] Problems with XP Conversion
> >
> >
> > > Just installed Windows XP Pro and am having problems loading
> > program.
> > > Error message "Could Not Open CW Driver" coming up. Also linked
> > sounds
> > are
> > > not coming up. When new spots appear a bell would sound when I
> > was using
> > > Windows 98 but under XP cannot get the bell. Checked sounds in
> > control
> > > panel and working ok. Reloaded program in from original disks but
> > did not
> > > solve problems. Am using Ver 3.05. Any help would be
> > appreciated.
> > >
> > > 73's Stu