[DSP-10] PLL locking and voltages at L21

[Chris]

Hi Mike

I can confirm the part is L21, output is from U6 pin 6. The voltage should 
be about 4v, I have tried moving the turns on the L21 coil  and adjusting 
using C69 with nothing more than a few milli-volt changes

73 Chris
----- Original Message ----- 
From: "kd7ts" <kd7ts at aceweb.com>
To: "Discussion of DSP-10 2-meter transceiver" <dsp-10 at mailman.qth.net>
Sent: Wednesday, December 31, 2008 4:50 PM
Subject: Re: [DSP-10] PLL locking and voltages at L21


> At 02:32 AM 12/31/2008, you wrote:
>>Hi all
>>
>> After getting by the loading of software and other tests, im wondering if 
>> anyone can help
>>
>>I have 9.1v at L21, is it best to run the udiag2.exe then go back and test 
>>the voltage here to see if I can get a locked status?
>>
>>Thanks Chris
>>_______________________________________________
>
>
> Hi Chris,
>
> I think you need to find out first why this voltage is there. Please 
> confirm the part number is L21. Maybe it is L22 ?
>
> 73 Mike KD7TS
>
> _______________________________________________
> DSP-10 mailing list
> DSP-10 at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/dsp-10