[DSP-10] X101 crystal soldering

[Jimmy Oldaker W7CQ]

At 11:54 PM 4/11/06, you wrote:
>According to the QST article I should be able to run the audio 
>processing on an input into the ADC jack. However, I cannot get 
>normal control from the PC software.

Dave

In your UHFA.CFG file the hardware and the hardware_ptt must be set 
to 0 (ZERO) to operate as a standalone audio processor.  This works 
and is fun to use.

See the capture of the Hardware section (about 2/3 of the way down 
the file) of the UHFA.cfg below, the last line and the 3rd from the 
bottom are the lines to change.

Still must be run from a DOS machine and not in a DOS window like 
Roger mentioned.

*****************************************

//*** Hardware (memch_hdw) ***
//
// The following six entries are the actual attenuation
// for rf gain settings 94, 88,...,64. Nominal values
// of -6.0, -12.0,...,-36.0.
rfgdb -7.87 -14.57 -18.47 -25.01 -31.88 -37.03
// gain_adj is small dB value to adjust power displays.
gain_adj 1.40
// hardware=1 normal DSP-10; hardware=0 audio processor
hardware 0
// hardware_ptt=1 fast PTT has been implemented; else 0
hardware_ptt 0



*******************************

Jimmy


   73's  -   W7CQ -   CN83jx