[DSP-10] X101 crystal soldering

[Roger Hayward]

Hi David:  Small world....

The crystal oscillator can   does not need to be soldered down by its case.

73,
	Roger KA7EXM www.ka7exm.net


-----Original Message-----
From: dsp-10-bounces at mailman.qth.net [mailto:dsp-10-bounces at mailman.qth.net]
On Behalf Of David Ohm
Sent: Tuesday, April 11, 2006 8:15 PM
To: dsp-10 at mailman.qth.net
Subject: [DSP-10] X101 crystal soldering

I am using an Epson CA-301 10 MHz crystal for X101. This is the same style
of crystal used for the X1..X4 parts on the board. Do I need to solder the
X101 can to the ground strip above the X101 pads? This was how X1..X4 were
soldered. 

Thanks!

Dave Ohm
KC0TSS
_______________________________________________
DSP-10 mailing list
DSP-10 at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dsp-10