[DSP-10] Files for Brickette PCB

[Bob Larkin]

Hi to all that are looking for files to make printed circuit boards for the 
8-Watt "Brickette."  I could not find the original zip file of Gerbers that 
made the PCB. So I made up a new zip, and I believe it is a complete set. 
The basic data is unaltered, and the only question would be a missing file. 
These are available for download from 
http://www.proaxis.com/~boblark/amp2.zip  These files are suitable for use 
by most board houses, including the prototype facility at AP Circuits in 
Calgary AB.

Then a big bonus!  Mike, KD7TS has redone the schematic and layout for PCB 
Express and made these available.  These have not been tested, but both 
Mike and I have looked at them. These are available for download 
http://www.proaxis.com/~boblark/bricket2.zip

Both sets of board files are intended to be the same as the ones in the 
June 2000 QST article.

Beb, W7SLB (Mashell Electric) is out of amplifier boards and will not have 
these in the future.

By the way, Beb does still have a few DSP-10 boards left, and I understand 
TAPR still has complete kits.

I hope this is useful for the amplifier boards. It should allow prototype 
quantities of boards, although those will probably not have solder mask or 
silk screen markings.  I suggest that this reflector might be a good place 
to coordinate a mini-group buy, as prototype runs will normally provide 
more than one board.

73,
Bob W7PUA