[DSP-10] Need Help!

[kd7ts]

Much to my later regret, I built my DSP-10 without a power switch and no way to
access the reset button on the ADSP board. If you need (want) to load the ADSP
with UHF3.exe, the board needs to be reset either by the reset button, or by
cycling the power off, then back on. The board indicates its willingness to
accept programming by a slow blinking of the red LED, ALSO INVISIBLE on my RF
tight enclosure, near the inaccessible reset button. 

I turn off the DSP-10 by pulling the power plug. It resets when power is
restored. 

If you are still running the Analog Devices PROM, there is some annoying music
and a female voice announcing a willingness to do something.

If you get the announcement, it is likely the reset has been accomplished.

If a UHF3 load is unsuccessful, be sure to reset before trying to load again.

Mike KD7TS