[DSP-10] Testing KDSP10/DSPx

Thu, 18 Sep 2003 01:11:07 -0500

Teik,
	I may have missed a message thread, but I am assuming that you have mounted
the DSP daughter board onto the carrier you built and applied the necessary
power?  The "greeting" comes from the DSP card, not the interface board
itself.  The DSP is preassembled and tested, with the EEPROM on-board.  The
message comes from this processor and firmware; the carrier is just an
application specific interface to the outside world.

Mike Niswonger, W4CMN

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Tan Teik Chuan
Sent: Thursday, September 18, 2003 0:48
To: [email protected]
Subject: [DSP-10] Testing KDSP10/DSPx

Yes, I have verified that my cable is correct. I shorted the pin 2 and 3
together, and could see the characters i typed echoed back to the HyperTerm.

But I just couldn't see the sign-on message "!!!  KK7P DSP Module Version
1.0 Rev C.1 !!!".
Can I really see the message on the HyperTerm by just powering up the board?
Or are there some other steps that I need to do?

Regards,
Teik Chuan

_________________________________________________________________
Using a handphone prepaid card? Reload your credit online!
http://www.msn.com.my/reloadredir/default.asp

_______________________________________________
DSP-10 mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/dsp-10