[DSP-10] KDSP10 Info

[Doug Bade]

         I am unable to get my dsp-10 kit which was working to pll lock 
with the new versions of hardware with dspx and kdsp board.

         I installed the dspx and kdsp-10 boards in my DSP-10 today and 
fired up the software. I corrected the path per the info in the readme and 
booted to dos...path looks good at command prompt. I copied the versions of 
dsp-10 files from the cdrom into the new directory of dspx which is a clone 
of my dsp-10 directory. I do the ez fast load of uhf3 and lights stop 
flashing, and 1 led is locked on. The other out.. last line says origin of 
0000 which does not look quit right....
         I then load uhfa  and it comes up, loads pointers, gets going and 
comes up with that dreaded "30 pll unlock" which plagued me during original 
startup of dsp-10 way back when..I do not know if an absolute fix was ever 
found, but as I recall I swapped chips around or something to get it going..

Any input would be helpful.

Any thoughts on how to correct or did I miss something else????

Doug KB8GVQ



At 09:58 AM 5/20/2003 -0700, you wrote:
>Hello Doug!
>
>No worries, I need a push from time to time :-)
>
>The www.kk7p.com website is now updated with the info you need to
>electrically interface the DSPx/KDSP10 to the DSP-10.
>
>73,
>
>Lyle
>
>
>_______________________________________________
>DSP-10 mailing list
>DSP-10@mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/dsp-10