[DSP-10] dsp-10 Audio only

[Gary Wilcox]

Is anyone on the list using the EZkit Audio Only. I downloaded the latest
software (3.04) and I am having trouble getting it to work correctly. I have
the "audio out" from my receiver connected to the "audio in" on the EZkit -
a set of amplified speakers connected to the "audio out" on the EZkit.

When I power up the Ezkit it seems to work fine. I can hear the welcome
message and then the audio from my radio. Can hear the audio on both output
channels.

I set hardware to 0 in the uhfa.cfg config file.

I use ezfast to load the uhf3.exe image and then start uhfa.exe. All seems
to be fine but I get no audio. The a/d indication on the bottom of the
screen seems to indicate I have input audio because the level  varies when I
increase the volume on the radio. The s-meter and waterfall display show no
signal present.

I have tried turning off the AGC and changing the AF gain RF gain.

When I change from USB to FM I get an indication on the S-meter but no
audio.

If I turn everything all the way up I get very faint distorted audio.

Again - when I hit the reset button on  the EZkit I can hear the audio fine.

Any ideas.
Thanks
Gary KE4VUN rgwilcox@bellsouth.net