[DSP-10] Choices of Oven VCXOs?

Fri, 1 Mar 2002 03:26:51 -0000

I am using a Fox surface mount VTCXO available from Mouser p/n
559-FOX801BE-1000 for $13.46 in quantity of 1. You must ask for the voltage
control option. I am using the TAC2 with ONCORE GPS receiver and the Brooks
Shera design both mounted in one enclosure. It took a bit of juggling the
resistor values (I used a 10 turn pot for one) to get the right control
voltage values. It works great. I am using the 10 kHz as the master
oscillator for my Ten Tec OMNI VI plus and for my Tectonics CMC251 (1.2 GHZ)
counter time base. I hope to stabilize the local oscillators for my 6, 2,
and 70 cm transvertors, but haven't yet got that working. I am trying to use
a VCXO with a divider and a divider from 10 mhz to drive a PLL. The 10 mhz
from the GPS conditioned oscillator being the control. If you know of any
source information, I would sure appreciate learning of it. 73 Dick.
----- Original Message -----
From: "Steven Bible" <[email protected]>
To: <[email protected]>
Sent: Friday, March 01, 2002 02:52
Subject: [DSP-10] Choices of Oven VCXOs?


> A question for the list,
>
> I've been surveying the available new oven VCXOs out there.  Has anyone
had
> any experiences with a particular model and company?
>
> I know there are several surplus oven oscillators out there (I won a few
> bids on eBay).  But I would like to know about some newly manufacturered
> units and peoples' experiences with them.
>
> Thanks,
>
> - Steve, N7HPR
>   ([email protected])
>
>
> _______________________________________________
> DSP-10 mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/dsp-10