[DSP-10] No tx out

[Rajiv Dewan, N2RD]

The receive seems fine.  The DSP-10 seems to hear better than my Icom
IC746.

I am, however, getting no power out.

D1-A2 0.82v -- so it seems biased ok
The DC voltages for MMICs and Q2 seem Ok too:
   U4 pin 3 measured 3.5 v suggested 3.6v
    U5 pin 3 measured 4.4v suggested 4.6v
   Q2 emitter measured 1.12v suggested 1.2v
   Q2 base measured 1.83v suggested 1.9v

I measured the AC voltage at U4 pin 3, U5 pin3 and Q2 collector
(across C51) using the probe shown in tests and measurements.  (The
probe works ok, I used it for measuring outputs of LO buffers).
And I get no AC voltage!!

What should I see at these pins?

An y help appreciated.
- -
Rajiv Dewan, N2RD
-----------------------
I regret that I do not accept any e-mail from:
 yahoo.com, msn.com, hotmail.com, lycos.com and excite.com
 because of excessive spam mail from these domains.
---------------------------