[Drake] Sheetmetal Screws for AC-4

[Jim Pruitt]

Hello Larry.

I did not see a reply to this message you posted, at least not an answer 
that answered the question so I will try.  Hopefully someone will chime in 
with what I am missing.

The sheet metal screws holding the upper U cover on are #4 sheet metal 
screws about 1/4" long.  My AC4 is in pieces so not sure where the bottom 
plate is or what screws it takes but the small sheetmetal screws are #4. 
>From memory (might be wrong) I think the bottom plate is held in with 6-32 
machine screws but if I am reading your question correctly you were only 
wanting to know what size the little sheetmetal screws are and they are #4.

I hope that helps.

Thank you.

Jim Pruitt

----- Original Message ----- 
From: <Telegrapher at att.net>
To: <Drake at mailman.qth.net>
Sent: Tuesday, December 22, 2009 1:17 PM
Subject: [Drake] Screws for AC-4


> The AC-4 supply i bought recently is missing most of the screws holding it 
> together.  The little sheet metal screws that is.  Is there a source for 
> them anyplace?
>
> Larry
> W0OGH