[Drake] T-4XB--no output

[Ron Wagner]

Paul,
Why don't you use the R4B as a signal tracer?  Basically take the antenna 
input and use a INSULATED piece of wire on the end of a coax to follow the 
signal inside the T4XB.  Since you know that you have signal and can peak 
it you can us the RX to follow it.  I use this technique often.  It was 
with this technique that I found a broken mica on a cap on the "rack".
73,
Ron
============================================================
Visit my astronomy home page.   http://www.dma.org/~wagner
Amateur Radio Station: WD8SBB - Ron  and  KB8NRP - Joann
============================================================
> With the R-4, I can detect a very low level of drive out. Adjusting the
> plate, preselector and load and drive does make a difference--I can hear a
> weak signal on the receiver, complete with audio, etc., and it's peakable
> using the transmitter controls.  I'm suspicious of components near and