[Drake] TR-7/R-7 extender boards

Sat, 17 Apr 2004 09:39:41 +0200

Be sure that these boards kit is ready to be used!
I ordered mine and I was very pleased when it arrived but very disappointed
when I had to use it: the boards were too wide and I had to remove about 3mm
of  FR4 board material on each side without connectors.
2 sides * 13 boards * 106mm = 2756mm x 3mm = 108" x 0.12" of material to
remove! :-(
After this hard work, you have to insulate all the solder layers with thick
tape (the tracks can touch the metallic walls), then, at last the boards
worked fine... :-)
Ciao and 73
Guido, ik2bcp / ab9dg

----- Original Message ----- 
From: "Stephen C. Finch" <[email protected]>
To: "'J. A. Call'" <[email protected]>; <[email protected]>
Sent: Friday, April 02, 2004 5:50 PM
Subject: RE: [Drake] TR-7/R-7 extender boards

A set of extender boards can be purchased here

http://www.atnet.net/~rsrolfne/

Steve
AI�W

-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of J. A. Call
Sent: Friday, April 02, 2004 8:18 AM
To: [email protected]
Subject: [Drake] TR-7/R-7 extender boards

Need a set of extender boards for the TR-7/R-7 units.  Any available?
Thanks

J
W7KSG
_______________________________________________
Drake mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/drake

_______________________________________________
Drake mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/drake