[Drake] Help:TR7

Mon, 6 Oct 2003 10:00:38 -0400

Most of the time, the fixed RCV and XMIT buttons must be out, and the AUX
switch should be in NORM if you have no AUX-7 modules installed.

73,
Russ
WB8ZCC

----- Original Message -----
From: "Stephen Finch" <[email protected]>
To: <[email protected]>; <[email protected]>
Sent: Sunday, October 05, 2003 11:05 PM
Subject: Re: [Drake] Help:TR7

> Make sure the RCV and/or XMIT (The fixed buttons) are in the out position.
> The receiver will act exactly that way if the RCV button is pushed in.
>
> Steve
> AI�W
>
> ----- Original Message -----
> From: <[email protected]>
> To: <[email protected]>
> Sent: Sunday, October 05, 2003 6:33 PM
> Subject: [Drake] Help:TR7
>
>
> > I am getting ready to try and get a TR7 working. The symptoms
> > are as follows.
> > It is open to noise when the antenna is attached
> > The display reads abt 17xx.xx and then proceeds to slowly count up but
> > on the 2 highest bans the display starts abt 16xxx.xx  and again it
starts
> > to count up.
> > I do have extra modules to try to get it going but a clue as to where to
> > start wud be greatly appreciated. Mny tnx in advance
> > Best 73 Morry K3DPJ
> >
> > _______________________________________________
> > Drake mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/drake
> >
> _______________________________________________
> Drake mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/drake
>