[Drake] Right Angle Plugs

[Ed Tanton]

You COULD easily roll you own David. Just clip most of the ground... uh... 
whatever it should be called... 'arm'(?) then wire your cable, and use some 
epoxy. Either putty, or use some small flat container (like the plastic 
bottom of a box-of-5 3AG fuses) and epoxy-cast the cable/plug back into it. 
Probably have to use something to hold that in place for the 5-min epoxy to 
cure. If you can find it, use epoxy gel-won't run that way. Shouldn't be 
too difficult to do. Then paint to suit.

At 12:17 PM 2003-05-29, David Drake wrote:

>Also tried the Newark website.  Got nowhere with searches.  Tried the
>switchcraft web site and only straight ones.  I'll try one or two other
>sources then I'm ordering 10 or 15 to pass on to other needy hams.  I'll
>keep track of responses, then post with the remaining available.
>Probably take a few weeks to get them.
>
>David Drake, WD9CMD
>
>
>_______________________________________________
>Drake mailing list
>Drake@mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/drake

73 Ed Tanton N4XY <n4xy@earthlink.net>

Ed Tanton N4XY
189 Pioneer Trail
Marietta, GA 30068-3466

website: http://www.n4xy.com

All emails <IN> & <OUT> checked by
Norton AntiVirus with AutoProtect

LM: ARRL QCWA AMSAT & INDEXA;
SEDXC NCDXA GACW QRP-ARCI
OK-QRP QRP-L #758 K2 (FT) #00057

--------------------------------------------------
"He that gives up a little liberty to gain
temporary security will lose both and
deserve neither".
--Benjamin Franklin

"Suppose you were an idiot ...
and suppose you were a member of
Congress...  but I repeat myself."
--Mark Twain
--------------------------------------------------