[Drake] Caig Deoxit/2A

Fri, 27 Sep 2002 16:50:07 -0500

Yes, Larry, use the DeOxit on your 2A, but use it sparingly.  I apply it
only in a drop at a time with an insulin syringe directly on each contact
wiper then put a drop in each tube socket pin while I'm at it.  Spraying the
switch isn't recommended, but I've not had any swelling problems using the
syringe.  Others recommend using a toothpick to place a drop where you want,
or anything similar.  Not sure what to recommend on the copper.  I choose to
leave it alone and only clean areas that need to be a good ground.
Vy 73,
Don, WB5HAK
----- Original Message -----
From: "Larry L. Laflamme" <[email protected]>
To: "drake" <[email protected]>
Sent: Friday, September 27, 2002 3:00 PM
Subject: [Drake] Caig Deoxit/2A


> I have heard so much about this product that I finally bought some.  It's
as
> good as everyone says, however there is some concern with swelling of
> wafers, etc.
>
> My question concerns the pre-selector on my 2A.  It's quite noisy and even
> intermittent.  Can I safely use Deoxit??
>
> While I'm on the subject, I must begin to remove some oxidation from the
> copper chassis.  I don't suppose anyone has an "easy" way to do it.
>
> Thanks
> Larry, N1SHM
>
> _______________________________________________
> Drake mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/drake