[DCboatanchors] Low Pass TVI filters FS

[Ken Simpson, W8EK]

Low Pass TVI filters For Sale:

Kenwood LF-30 A
This is Kenwood's low pass filter, with a cut off of
about 30 MHz, and more than 90 db of attenuation
between 90 and 300 MHz.  It will handle 1000 watts,
and has an SO-239 connector on each end.  It is in
extremely nice condition. These are $65 new; get 
this one, with paper work for $35.

Nye Viking Low Pass Filter Model 020-001
This filter is rated at 2000 watts, with over 65 db of 
attenuation above 57 MHz.  These are about $60 new; 
this one is close to new for only $35.

Johnson 250-20 Low Pass Filter
This is a 52 ohm cylindrical low pass filter with a cut 
off frequency of 45 MHz and 75 db of attenuation. 
It is rated to take 1000 Watts of AM, or 5000 Watts 
PEP SSB.  It has SO-239 connectors on each end.
$30.

Drake TV-3300-LP Low Pass Filter
This is a modern low pass filter to go between your
transmitter and antenna, and has been optimized to
have more attenuation in the 40 MHz region, where
many TVs have their IF.  According to the manual it is 
good for 1000 Watts "average", which would be about 
2000 watts PEP, and has over 80 db attenuation at 
41 MHz.  SO-239 connectors on each end. This one 
looks close to new, and also has the single page 
"manual" with it.  $ 30

Drake TV-1000-LP Low pass filter 
This is the filter that is in the copper case, and may also 
be used on the low end of six meters, as well as HF.  It is 
a 50 ohm filter and is good for 1000 W below 30 MHz, and 
about 200 W up to 52 MHz.  With paper work for $ 30

B & W  model 425 (Also know as FL-10/1500) low pass filter
B & W  TVI filter, 50 ohm. It cuts off just above 10 meters, 
and will handle 1500 Watts. SO-239 connector on each 
end. It is in very nice condition for $ 25.

MFJ 704 low pass filter
This filter is made to go on the output of your rig to
help get rid of TVI and harmonic interference.  It is 
rated at 1500 Watts, even with a 2:1 SWR, and is 
in a very study black metal case with SO-239 
connectors on each end.  Operating frequency is 
listed as 1.5 to 30 MHz.  It is a 50 ohm filter.  This 
one works fine and looks very close to new. These 
are $50 new, but you can have this one for $35

Alinco ELP-60 D LX low pass filter
For 50 ohm systems, with up to 500 watts of power.
This one has an SO-239 on one end, and about a 2 foot
length of coax and PL-259 on the other end.  $30

Ameco LN-2 low pass filter
This filter is rated at 100 Watts, with an SO-239
connector on each end.  $12

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at speakeasy.net or W8EK at arrl.net
Voice Phone  (352) 732-8400