[DCboatanchors] Ham Rotor and accessories FS

[Ken Simpson, W8EK]

Ham Rotor and accessories For Sale:

Ham M Rotor and Control Box
The Ham M is rated for up to a 24 foot boom antenna and 10.5 
square feet of antenna..  This one is in good shape, but has had 
a couple modifications to the control box, to make it similar to 
the Ham II and Ham III control box.  Two knobs have been added 
at the lower left and lower right, below the meter.  One is an on-off
switch, and the other is the calibration control, brought out to the 
front so one does not need to reach behind the control box as was 
done originally.  In addition, a zener diode has been added to 
stabilize the voltage for the position indicator.  With paper work 
and stainless steel hardware for $185.

Ham M control box only
This is a series 4 control box only, and is in nice condition.  Paper
work is included for $70.

Lower mast support
Heavy duty type, made to go with the Ham IV, but can be used on 
any of the "Ham" series of rotors.  I do not think this one has been 
used, as it is still in the plastic.  It includes stainless steel
hardware.  
New, these go for about $90.  Get this one for $50.

Lower mast support
This is also the heavy duty type, as used on a Tail Twister rotor.  It
is heavier duty than the Ham IV lower mast bracket. This one has been 
used.  It includes the clamps to clamp to the mast, and one stainless 
steel U bolt and hardware.  One U bolt is missing, but can easily be 
obtained locally.  $45

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at speakeasy.net or W8EK at arrl.net
Voice Phone  (352) 732-8400