[DARARepeater] CCS Linking on Icom Radio

[Mark Fairweather]

Hello, you can ignore my request now but if I could perhaps correct an error on your site for you so that other users don't scratch their heads as I did :-) 

In the CCS linking info you state to disconnect then you can issue DTMF "A" or URCALL C - this is incorrect , the actual disconnect in the URCALL field should in fact be CA - this entry in three Icom radios works perfectly, IC-2820 / ID-51E and the Icom IC-7100. I hope this may be of help.

Regards
Mark
G0TOV

Sent from my iPad

> On 20 Jan 2016, at 22:05, Mark Fairweather <mark.fairweather at btinternet.com> wrote:
> 
> Hello, I read with interest your section on operating CCS07 linking on newer Icom radios. I have followed your instructions and I cannot seem to get the system to disconnect me using the URCALL C command, could you please tell me has this command been replaced but your page not updated to reflect any change ? I connect to another station using C235xxxx but I cannot disconnect on either an Icom ID-51E or Icom IC-880 unless I send an "A" (no quotes) from the CQCQCQ field. Could anyone please advise.
> 
> Thank you in anticipation.
> 
> Mark
> G0TOV
> 
> Sent from my iPad