After about 30 minutes with a hacksaw, a bench grinder, and a drill press I was able to make a couple of decent bases for my CTE-2600A ‘flameproof’ keys out of 1/8” steel plate.  Used stainless steel machine screws, self-locking nuts, and rubber pads to finish it off.  The added weight upon the rubber feet keeps the key from ‘wandering’ around the desk.  This was a good afternoon project that will last forever.  Nope, it isn’t an original part… but works out quite well.

Jim Hull

image0.jpeg

image1.jpeg

Sent from my Glade Air Freshener

On Jan 6, 2023, at 1:29 PM, D.J.J. Ring, Jr. <[email protected]> wrote:


Too bad someone didn't buy Nye-Viking, when the owner passed away. He made good products and he sold metal bases for his oval and rectangular bases. With the increase of new Morse interest, maybe some retired fellow would being them out again, and maybe even make the semi-automatic keys that Nye had the rights to make and continue the old Johnson straight keys and bugs.

Here is a fellow that is selling the original bakelite base for a J-38.

There are other sellers on eBay that sell bases for the flameproof key.

https://www.ebay.com/itm/265597127105

73

DR
______________________________________________________________
CW mailing list
Home: http://mailman.qth.net/mailman/listinfo/cw
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
CW List ARCHIVES: http://mailman.qth.net/pipermail/cw/
Unsubcribe send email to
[email protected]
Subscribe send email to [email protected]
Support this email list: http://www.qsl.net/donate.html

=30=