[CW] MMANA-GAL - HamSoft

[. PA0WV]

What I remember from MMNANA NEC is that you, as user, can draw an antenne by specifying height and traps in numbers, takes quite some effort, and the result is impedance at feed point and direction diagram. 
But when you say what length of dipole do I need en what value of L and C in traps, that is not possible as far as I understand. 
Or another question: when I have a feeder to a dipole with characteristic impedance Zo with length L, what length must the dipole have in order to tune it with an LC tuner to 50 ohm with a C of 20-500 pF, in an auto tuner. Even the requirement of a specified limited impedance in the Smith Chart, on the feeding point, from 80 or 160 to 10, is AFAIK not possible.

Translations of text is no problem today, any language is computer aided for free, translating instantly by written or even spoken text.

73=30
PA0WV
> Op 25-09-2026 15:01 CEST schreef D.J.J. Ring, Jr. via CW <cw at mailman.qth.net>:
> 
> 
> MMANA-GAL Antenna modeling software.
> 
> https://hamsoft.ca/pages/mmana-gal.php
> ______________________________________________________________
> CW mailing list
> Home: http://mailman.qth.net/mailman/listinfo/cw
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:CW at mailman.qth.net
> CW List ARCHIVES: http://mailman.qth.net/pipermail/cw/
> Unsubcribe send email to
> cw-unsubscribe at mailman.qth.net
> Subscribe send email to cw-subscribe at mailman.qth.net
> Support this email list: http://www.qsl.net/donate.html
> 
> =30=