[CTSARA] Newbie question: radio/antenna grounding using electrical system

[Jonathan Shapiro]

AC line  is not an RF ground. Your radio should be grounded to a copper cold
water pipe.  Note that the length of the pipe to true earth could be a
significant fraction of a wavelength.  If the length of pipe to  earth is
1/4 wavelength then your equipment will be RF hot and you will get an RF
burn. It may be good for DC or 60 hz AC,  but any length of wire is also a
RF impedance.

If you have problems with RF, use an isolating balun.

For info go to www.radioworks.com
 and go to jim's notebook for articles on antenna grounding.

Also check out ARRL antenna book

73

Jon Shapiro
AB1HI

jon at giciman.com



-----Original Message-----
From: ctsara-bounces at mailman.qth.net [mailto:ctsara-bounces at mailman.qth.net]
On Behalf Of Andrew Rosca
Sent: Wednesday, June 30, 2010 2:42 PM
To: ctsara at mailman.qth.net
Subject: [CTSARA] Newbie question: radio/antenna grounding using electrical
system

Could the third (grounding) connector in a regular power outlet be used for
grounding a radio station? How about an antenna?

Thanks
______________________________________________________________
CTSARA mailing list
Home: http://mailman.qth.net/mailman/listinfo/ctsara
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:CTSARA at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html


CyberDefender has scanned this email for potential threats.
Version 2.0 / Build 4.03.29.01
Get free PC security at www.cyberdefender.com