[Collins] Collins S line in transciever mode

[Dr. Gerald N. Johnson]

Message took three months to arrive.

The RX VFO output cable needs to go to the TX VFO input and the switch 
should take care of changing the VFO source and also turning off the 
power to the TX VFO when using the receiver VFO. Has the power switch 
been replaced and not wired correctly?

73, Jerry, K0CQ Technical Adviser to the Collins Radio Association.

On 9/17/2015 10:11 PM, David Place wrote:
> What am I doing wrong?  I have run the two coaxial cables from the
> transmitter to the receiver and connected the other wires for VOX etc.  I
> have unplugged the crystal bank in the transmitter of course to allow the
> cable from the receiver to be plugged in to that jack.  For some reason, the
> transmitter still requires me to use its VFO to change frequency.  I have
> the selector switch on Rec VFO.  I though from the manual that this would
> allow me to use the receiver to set the frequency I am using, thus having a
> transceiver set up. It is not working.  Any suggestions?
>
>
>
> Dave VE4PN
>
> ______________________________________________________________
> Collins mailing list
> Home: http://mailman.qth.net/mailman/listinfo/collins
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Collins at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>