[Collins] FS: Misc Collins 30S-1 Parts

[J Allen Call]

Twelve (12) solder type coiled wire connectors and three different inside diameters.  There are four, three inch lengths, which will fit over the size of wire used on 1/2 watt resistors. There are four, three inch lengths, which will fit over the size wire used on 2 watt resistors, and there are four, three inch lengths, which will fit wires up to size #10.  These connectors are very handy where a component is mounted on the top side of a PC board and is soldered on the back of board.  They are very simple to use.  Just clip the wire of the bad component close to the body, on both sides, remove the bad component. Now cut the wires of the new component to fit the available space. Select the diameter of the wire connector needed, cut a piece to the desired length.  Insert the wire connector into one of the wire on the PC board, then place one end of the replacement part into the wire connector.  Do the same on the other end.  Adjust the wire connector so that it is centered  between the two wires and then solder.  Do the same on the other end.  It will produce a professional solder joint.  Picture if desired.  $12.95 shipped.
JAC