[Collins] testing 51J4 filters?

[Greg]

Sure:

Pump the IF frequency into the filter via the signal generator and use the 
oscilloscope probe at the output pin.
You should see a signal on the scope around the IF freq but much lower in 
strength from the input side.
This should answer the "likely to work" question.
You can do this same test with a quartz crystal too.  The Q is so freakin 
high with quartz you have to tune very slowly in order to catch the scope 
response and I wouldn't sweep it with a squiggly kind of generator.
Have fun!
Greg
WA7LYO
Kinston NC

----- Original Message ----- 
From: <eugene at hertzmail.com>
To: <collins at mailman.qth.net>
Sent: Wednesday, November 14, 2007 8:41 PM
Subject: [Collins] testing 51J4 filters?


Hello all,

Finally found a 6.0kHz mech filter for my 51J4 (also got a 1.4 too).
Problem is, my 51J4 is inoperative presently. I was wondering if there
are some simple tests I could perform on these filters that might tell
me either they work, or are likely to work? Or perhaps that they are
dead? Test equipment available includes rf generator, scope, hp410B
meter. Are there some simple tests I could perform?

Thanks
Eugene w2hx

______________________________________________________________
Collins mailing list
Home: http://mailman.qth.net/mailman/listinfo/collins
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:Collins at mailman.qth.net