[Collins] 32V2 no grid drive

[C Eus]

Yes, give that a try! I had a 32V2 that "smoked" a
resistor due to a bad bypass cap. This happened a few
years ago. The load resistor was located in the driver
can. While you're there, think about changing out
those silvered mica postage stamp caps. Don't ask me
how I know this! 

Cal, N6KYR/8. 
--- Albert Santangelo <ve3ajm at sympatico.ca> wrote:
> I've discovered no B+ voltage at pin 8 of the 6AG7
> first multiplier
> tube. Screen voltage is okay. All other voltages in
> the RF driver
> section check out fine as per the manual.
> 
> I'm suspecting R109, a 1K resistor as open circuit.
> Looking in under the
> tube sockets in the RF driver section, I can't seem
> to locate R109. Is
> it located inside the can for L104? Any help would
> be appreciated.
> Thanks.
> 
> Al Santangelo  VE3AJM
> 
> 
>
______________________________________________________________
> Collins mailing list
> Home:
> http://mailman.qth.net/mailman/listinfo/collins
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:Collins at mailman.qth.net
> 
> 

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com