[Collins] KWS-1 Part Needed

[The Shultz's]

While trying to get my KWS-1 to restored to operating condition, I had to
remove the RF cage to repair the PA roller inductor. During the disassembly
I also had to do some work in the grid compartment and removed the metal
plate that connects the grids of the 4CX250's through the chassis to the
driver stages. When I went to reassemble everything, this odd shaped plate
turned up missing! I have torn the workshop apart looking for it and have to
conclude that it may have fallen off the bench into the wastebasket and I
will never find it!

Does anyone have one of these? If not, does a drawing exist so that I may
fabricate one? I can guess at the dimensions and they may not be critical
but then again someone went to a lot of trouble to make a complex piece of
metal for some reason.

Thanks in advance from a very frustrated NJ2R, Roger