[Collins] KWS-1 HV Connectors Needed

Mon, 15 Dec 2003 20:57:22 -0600

FROM: Gene Nailon  K5DLE  [email protected]
Edmond, OK
15 Dec. 2003

Hello Roger, NJ2R;

The connector on the back of the KWS-1 (J402) is a:

MS3102A-14S-4P  BULKHEAD CONNECTOR. It has one (1) Male pin.

The mating connector from the power supply on the end of the
HV wire is a:

MS3106A-14S-4P  with strain relief. It has one (1) Female pin.

Both are available and INSTOCK (NEW) from:

ELECTRO ENTERPRIZES, INC.
Okla. City, OK
(405) 427-6591

MS3102A-14S-4P  $14.00  MS3106A-4S-4S  $16.00.  Plus Freight.

Ask for Cheryl.

Good luck on the Box!!!

73,

Gene
=============================================================

Wed, 10 Dec 2003
From: Roger Shultz <[email protected]>

To: Collins QTH <[email protected]>

This may be a long shot but is anyone parting out a KWS-1 and has
both the male and female HV connector set as well as the small
square box on which the male HV connector is mounted and that
mounts on the rear of the PA cage?

I would be very grateful if there is one out there.

If none is available, I will probably use the old Millen HV
connector set with the bypass cap mounted inside the PA cage.
Currently there is a ceramic feed through insulator in place of
the box and while its functional, it is dangerous.

Other methods to resolve this "modification" are appreciated as
well.

73, Roger NJ2R
==========================================================