[Boatanchors] Tube Oscillator Circuit Question

[Walt Cates]

I mis-read your statement on the plate voltage. I'll try again.
While oscillating;
   What is the screen voltage?
   What is the voltage at the junction of the 10K and the two 100K resistors?


 Walt Cates, WD0GOF
https://wd0gof.com/Hallicrafters

A majority of acceptance is not proof of correctness.
https://wd0gof.com/bible-study/commentaries/


________________________________
From: boatanchors-bounces at mailman.qth.net <boatanchors-bounces at mailman.qth.net> on behalf of whitebear1122 at comcast.net <whitebear1122 at comcast.net>
Sent: Sunday, December 13, 2020 12:02 PM
To: boatanchors at mailman.qth.net <boatanchors at mailman.qth.net>
Subject: [Boatanchors] Tube Oscillator Circuit Question

I am working on resolving one of the two remaining issues with my HBR-13 12
tube dual conversion superhet receiver.  The receiver works but the BFO
waveform has bothered me since I built it.



The output of the oscillator is not a nice sine wave as I was expecting.
The photo shows the oscilloscope at the oscillator plate pin 5.  Amplitude
is about 96 volts p-p.  I pulled the tube to measure DC voltage applied to
pin 5 and 6,  151v.  The waveshape on the tuned circuit side pins 1 and 2
looks good, a normal sine wave.  I just don't know what I'm seeing.  Any
advice is appreciated.  Thanks. 73, Scott WA9WFA



https://www.qsl.net/wa9wfa/HBR13_BFO

______________________________________________________________
Boatanchors mailing list
Home: http://mailman.qth.net/mailman/listinfo/boatanchors
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Boatanchors at mailman.qth.net

List Administrator: Gary Harmon, K5JWK
** For Assistance: gharmon at idworld.net **


This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to cateswa at msn.com