[Boatanchors] [Milsurplus] Dynamotor Power Supply.

[David Stinson]

> I have one of those I bought several years ago 
> on eBay but have not yet used.  What is the load
> sharing connection that is required 
> to double the two outputs up?
> 73 de Mac, K2GKK/5

Here is a technical sheet on the Astec MVP
supplies:
http://www.farnell.com/datasheets/13491.pdf
https://www.artesyn.com/power/assets/mp1_revc_1192
808420_install.pdf

on the end of each module is a 10-pin ribbon cable

connector.  Set the output voltage of each module
as 
closely as possible to the same voltage, then
connect
pin 8 on each connector together.  This will cause
the
power supplies to load-share.