[Boatanchors] Testing 01A and 301A tubes

[Bob Sullivan]

Joe,

Setting for the TV-7;

01A
Fil; 5.0v
Selectors; ER3-2000
Bias; 48
Range; B  
Press to test; 3
Min value is 18

No info on the 301A, sorry.

73, Bob
WØYVA
http://www.isquare.com/personal_pages/ras-hardware.htm

On Dec 19, 2014, at 3:49 PM, Joe W2KJ <w2kj at bellsouth.net> wrote:

> I just picked up a nice Atwater Kent 20 receiver (big box) and checked the filaments of the tubes and they were OK...so far so good.
> 
> I have a Hickok 752A tube tester but there is no listing for these tubes.....there is a 4 pin socket on the 752A in which the tubes will plug in and fit.
> 
> I've seen where folks have tested these tubes on a TV7 (essentially same circuit as 752A).
> 
> Any suggestions on how to test these tubes on my 752A?
> 
> Settings in particular??
> 
> Many thanks for any assistance...I'd like to get this fine receiver back up on the air again.
> 
> 			73, Joe W2KJ