[Boatanchors] Casting radio knobs

[J. Forster]

Here was my reply:

I'm not aware of such a site, but casating out of resin is routinely done.

A friend used to make custom knobs and other specialty parts for General
Radio, and I worked with him a few times.

Step 1: Design and make a master of what you want out of aluminum (or
possibly a hard, machinable plastic) using a lathe and Bridgeport. In the
design stage remember you have to get it OUT of the mold when the part is
hardened.

Step 2: Spray the part with Teflon mold release, then embed the master in
silicone rubber (two part rubber that uses a catalyst).

The easiest way is to put a knob master on a shaft and suspend it in the
rubber.

To avoid blowholes, put the mold an rubber into avacuum chamber for a
copuple of minute4sw and pump until the bubbles stop,.

Let the rubber set. Then remove fron the pipe, cut the rubber mold into
two pieces with a knife, and extract the master. A short length of PVC
pipe non a piece of Masonite will form the exterior of the mold.

    support
       |  <....pour rubber in
    |  |   |
    |  O   |.... pipe
    |      |
===================  ...Masonite

Step 3: Spray the silicon mold inside with mold release, reassemble,
reinsert into the pipe. Mix the epoxy and pour into the mold, pump down,
then leave to set.

Step 4:  Remove casting and finish on lathe or mill.

The epoxy is usually mixed from clear thin resin, catalyst, and a filler,
like powdered stone or another mineral filler, and a color

Best,

-John

=======================

nj


> Bob,
>
> Could you summarize for those of us who may also have a similar need?
>
> Thanks,
> Ken
>
> On 6/27/2012 6:11 AM, Bob Jackson wrote:
>> Many thanks to all that responded with TONS of useful "how to" info as
>> well as links to same. I think I can take it from here.
>>
>> Bob  AG5X
>
> ______________________________________________________________
> Boatanchors mailing list
> Home: http://mailman.qth.net/mailman/listinfo/boatanchors
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Boatanchors at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>