[Boatanchors] in need of a panel mount BNC female

[jmfranke]

I find it easy to make a blank four-hole 1" square flange, drill the four 
mounting holes and then add a single-hole or four-hole BNC connector. The 
four hole BNC connector must be rotated 45 degrees so the two hole patterns 
do not overlap. To save screws, the BNC connector can be sweat soldered to 
the 1" square flange, assuming it was made from brass.

John  WA4WDL

--------------------------------------------------
From: "W2HX" <w2hx at w2hx.com>
Sent: Wednesday, April 25, 2012 11:08 PM
To: <mrca at mailman.qth.net>; <TestEquipTrader at yahoogroups.com>; 
<boatanchors at mailman.qth.net>
Subject: [Boatanchors] in need of a panel mount BNC female

> Hi all,
>
> I am in need of (2) of a particular panel mount (4 hole flange) BNC 
> female. Because it needs to replace an existing SO-239 the dimensions must 
> match.  Basically - does anyone have something like the drawing below (see 
> link)?  Yes, I could buy two from pasternack and spend $30 but that seems 
> a little excessive to me.  I don't care if they're new or used, but the 
> unit must have a 1 inch square panel flange and the holes must be 0.718 
> inches apart for it to fit.  Anyone have this item exact in their junk 
> drawer? Or anyone have a good suggestion of where to look for one of 
> these? I checked mouser, digikey to no avail.
>
> http://www.pasternack.com/images/ProductPDF/PE4395.pdf
>
> Yes, I could use adapters but would rather avoid if possible.
>
> Thanks!!
>
> 73 Eugene W2HX
>
>
>
> ______________________________________________________________
> Boatanchors mailing list
> Home: http://mailman.qth.net/mailman/listinfo/boatanchors
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Boatanchors at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>