[Boatanchors] Hali. SX-101A

[Bill Stewart]

Hi Bob,
The reason I was looking for a good labeled parts layout is to help ID the various resistors and caps. As I remember, the Sams, etc, usually had a well labeled pix to go with their info. I'm using the schem., but a well labeled pix would help locate the parts a little quicker. Tnx, Bill


----- Original Message -----
From: "rbethman" <rbethman at comcast.net>
To: "boatanchors" <boatanchors at mailman.qth.net>
Cc: "Bill Stewart" <cwopr at embarqmail.com>
Sent: Sunday, August 7, 2011 6:52:22 PM
Subject: Re: [Boatanchors] Hali. SX-101A

Bill,

Take GOOD photos before you start!

That and the Original manual should be more than adequate.

You are dealing with Black beauties, Tiny Chiefs, and some Tubular 
ceramic NPO caps in the whole IF/RF under the chassis.

Bob - N0DGN

On 8/7/2011 6:29 PM, Bill Stewart wrote:
>
> Does anyone know if there is available a Sams or similar pub. that shows pix of  the bottom layout of resistors/caps, etc . I have the orig. manual, but additional info would be helpful in working on this one.
>
> Thanks&  73, Bill K4JYS
>