[Boatanchors] SP-600 J-11

[jmfranke]

From: http://www.radioblvd.com/sp600_rebuild.htm

The Crystal Controlled Switchable Local Oscillator ("X" option)

This unit allows the operator of an "X" optioned SP-600 receiver to 
substitute a crystal LO for the regular LO for increased stability. Six 
crystal sockets allowed the user to install HC-6 crystals for fixed 
frequency operation. A six position switch allowed selecting any of the 
crystals installed. A vernier frequency control was also provided. The 
crystal switch and the frequency vernier were brought out as two extra 
controls added to the upper right section of the front panel.

When selecting a Crystal Controlled LO frequency, only the LO is changed - 
you will still manually have to tune the receiver to the selected operating 
frequency in order to have the RF and Mixer stages also tuned correctly. 
You'll need to install the correct frequency HC-6 crystal which is not the 
same frequency that you want to tune in. The manuals will provide the 
formula to calculate the crystal frequency required for the desired receive 
frequency. Basically, 455kc or 3.955mc is added to the desired receive 
frequency to obtain the correct crystal frequency depending on the band and 
whether the receiver is operating single or double conversion. Also, on the 
higher frequency bands the result is divided by 3 or 4 for operation on the 
crystal frequency harmonic.

John  WA4WDL

--------------------------------------------------
From: "Radios R. Me" <radios_r_me at yahoo.com>
Sent: Wednesday, March 10, 2010 3:14 PM
To: <boatanchors at mailman.qth.net>
Subject: Re: [Boatanchors] SP-600 J-11

> Thanks Bob - do you know if these are fundamental crystals that just run 
> at, or close
> to the desiredreceive frequency? If so, are the FT243 types (if you happen 
> to know!)
>
>
> I had a couple of people asking me for crystals for their SP600 radios, so 
> they
> must be the versions of the radio that have the sockets in them already...
>
>
> 73 - Brian "Bry" Carling, AF4K
> = = =
> Please use my main e-mail address:  af4k at hotmail.com
>
>
>
>
> ________________________________
> From: rbethman <rbethman at comcast.net>
> To: Boatanchors Mail List <boatanchors at mailman.qth.net>
> Cc: Radios R. Me <radios_r_me at yahoo.com>
> Sent: Wed, March 10, 2010 12:01:50 PM
> Subject: Re: [Boatanchors] SP-600 J-11
>
> Bry,
>
> The Northern SP-600 doesn't have the module that is in the JX-17 for
> crystal placement and selection.
>
> That module came along quite a bit after the "early" variation.
>
> They allow for fixed frequency use, I think.  Not having had one of
> those, I can't really say.
>
> The Northern Radio contract, NO bsr 57519, apparently was in the '50s.
> It had as part of the "system", two of their SP-600s, a LMO, Local
> Master Oscillator, and speaker all in a rack.
>
> The LMO would set the frequency for BOTH receivers.  There were two
> antennae, one attached to each receiver.
>
> Well, I got a bit long.  However, I do not see immediately, a way to
> add this crystal module, and certainly have never seen them separate.
> I believe that they were factory installed.
>
> Bob - N0DGN
>
> On 3/10/2010 10:57 AM, Radios R. Me wrote:
>>
>>Hi
>>Bob - do you know if there is some scheme for adding crystals in the
>>SP600?
>>>I have had a few folks asking me about this lately.
>>
>>>If so, would they be for fixed frequency operation? extra bands or what?
>>
>>
>>>73 - Brian "Bry" Carling, AF4K
>>
>>= = =
>>>Please use my main e-mail address: af4k at hotmail.com
>
>
>
>
> ______________________________________________________________
> Boatanchors mailing list
> Home: http://mailman.qth.net/mailman/listinfo/boatanchors
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Boatanchors at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>