[Boatanchors] Globe Electronics Globe Chief 90A

[Glen Zook]

WRL and Globe Electronics were the same company, owned by Leo Meyerson.

Glen, K9STH

Website:  http://k9sth.com


--- On Fri, 12/10/10, Bill Stewart <cwopr at embarqmail.com> wrote:

A while back I acquired a Globe Electronics Globe Chief 90A with the intention of using the pwr. trans. in a defunct WRL xmtr. However, even though, this xmtr looks rough cosmetically, the wiring looks good. I just fired it up and its putting out power. At the moment the band switch is extremely hard to turn, so will probably take it out and clean and lub. Also, on 80m (the only band tested so far), I get some grid drive (not sure if its enough) with the grid tuning full ccw with no peak, which should be the 40/20 mtr position. And another problem noticed is the output peaks way off the dip. So there are a few problems to iron out, but its alive.  
 
Does anyone have a schematic and/or parts list or can point me toward this info or does anyone have a scanned manual for this xmtr. The schematic on BAMA is for the WRL version of the Globe Chief 90A.