[Boatanchors] metal dial plates

[David Knepper]

Could anyone assist me in securing metal dial plates for my Collins 
reproduction project?  I am searching for a company that could press out the 
calibration lines from 0 to 100 for a dial plate to make some dials for an 
older pre-World War II Collins transmitter.

These dial plates measure about 4 inches in diameter and are either nickle 
plates or ??

Also, I am looking for 3" inch knobs that were made by General Radio.  I can 
forward jpegs of the dial plates and knobs if you need them.

Any leads would be appreciated.

Thank you
David Knepper, W3ST/W3CRA
Secretary to the Collins Radio Association
www.collinsra.com
Publisher of the Collins Journal
Join the CRA - the world's largest Collins group