[Boatanchors] AC inputs?

[eugene at hertzmail.com]

Hi All,

Picked up a TMC antenna multi-coupler.  It has a 3-pin mil connector
that thanks to folks here, I have ordered the mating connector to make a
cable. Question has to do with hot/neutral.

So I was investigating how to wire this up and was trying to figure out
which pin is hot and which is neutral.  Ground was easy to figure out.
Far as I can tell, it shouldn't matter on this which is which, but I
wanted to check with the experts. 

The two wires (hot and neutral) come in from the connector. Each passes
through a fuse (the neat kind that light up when the fuse has blown!) so
far, since both sides are fused, I think I'm ok. Then the fused sides go
to a DPST on/off switch. So far so good.

Then these switched wires go directly to the primary of the power
transformer...So it seems to me that there is no specific hot and no
specific neutral.

Can anyone confirm that some equipment is build this way and that it
might not matter?

Thanks
Eugene