[Boatanchors] Johnson Invader 2000 Question

[Al Parker]

Hi Mark,
    Are you gonna hv it on for the CX?  Mine's ready.
    The fan is powered by a female pin jack that comes out of the cable
that plugs in just below it.  I haven't gotten the skem out to see which
pin it comes from at the other end where it goes into the upper P.S. secn.
amd don't remember if it's 120vac or 6vac.  Don't know where to get the
jacks & pins, either.
    Hope that's some help.
CU Sun.
73,
Al, W8UT
New Bern, NC
BoatAnchors appreciated here
http://www.thecompendium.net/radio/
http://www.hammarlund.info


----- Original Message ----- 
From: "Mark Bell" <bell at blazenet.net>
To: "Boatanchors List" <boatanchors at mailman.qth.net>
Sent: Tuesday, September 21, 2004 9:00 PM
Subject: [Boatanchors] Johnson Invader 2000 Question


> According to the manual,  the exhaust fan on the rear of the Invader is
> supplied via
> J205.
>
> The "High Voltage and Control Cable" drawing (Page 44) shows a
connection
> from the cable to J205,  but nowhere in the manual does is say where
J205
> gets it voltage from !!!   I'm assuming it's from pin 1 of J303,  as
that
> goes to the motor (which I assume is below the tubes).   Can anyone
verify
> this?
>
> Thanks
> Mark K3MSB
>
> _______________________________________________
> Boatanchors mailing list
> Boatanchors at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/boatanchors
> ** List Administrator - Duane Fischer, W8DBF/W9WZE **
> ** For Assistance: dfischer at usol.com **
> $$ For vintage radio info, see the HCI web site $$
> http://www.w9wze.org
>
>