[Azden] Mic Pins needed for 2000

Sat, 6 Mar 2004 21:15:16 -0500

I can provide that info if I go to the file cabinet, but I'd like to
suggest something different that has worked very well on the 3000.

Install into the microphone (assuming you actually have one) a stereo
jack of the miniature variety.  That's the one with the diameter of less
than 1/8 inch.  It mounts very nicely on the side.

Connect one side of the jack to PTT and the other to the microphone. 
Then, make up a cable from the TNC that has two plugs on it.  One is mono
and an 1/8 inch dia that goes to the speaker output jack on the 2000
(receive audio).  The other matches the jack on the microphone and
carries transmit audio and PTT.  You use different diameter jacks/plugs
so that you cannot interchange them.

Then, when you want to use the TNC, you connect both plugs.  When you
want to use the set normally, you remove the plugs and off you go.

Get back to me if you actually need the mic connections

Ed
K1ZOK

On Sat, 6 Mar 2004 15:49:43 -0800 "Keith Marshall"
<[email protected]> writes:
> Anyone have the pin layout for the Mic on the 2000.
> 
> I want to hook mine up for APRS.
> 
> Thanks,
> Keith 
> KD7KPY
> _______________________________________________
> Azden mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/azden
> 
> 

________________________________________________________________
The best thing to hit the Internet in years - Juno SpeedBand!
Surf the Web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!