[Azden] Mic Pins needed for 2000

[Keith Marshall]

Well Ed,

I tried something that worked with my mic connection that did not waste a
mic plug or even hurt a mic.

I made a costume plug. I got 4 pins from a electronic shop and placed then
on pins 11, 12, 9, and 2 and then wired them up then packed them with a hot
glue gun :)

It does not look like a highend job but it sure does the job.

But now I found out that one of my 2000s has a TX issue and the other has a
RX issue. As I needed to make a power connector for these guys I had not yet
tested them till now :(

Just a FYI on my status :)

Keith
KD7KPY


----- Original Message ----- 
From: <ma.locksmith@juno.com>
To: <azden@mailman.qth.net>
Sent: Sunday, March 07, 2004 6:02 AM
Subject: Re: [Azden] Mic Pins needed for 2000


> However, I do not suggest trying to use the connector by itself.  The
> contacts are easily damaged and are the removable type, but you have to
> have a special tool to remove them.  I have no idea where to get more.
> That is one of the reasons I went to the "jack in the mic" solution.
> Have done it on a number of sets and all worked fine.  The connectors for
> the 2000 and 3000 are now, and have been for many years,
> unobtainable.....  worth their weight in gold.