[ARC5] [Milsurplus] BC-221AK Question

[JAMES FALLS]

Regarding 221s and LMs, I have an LM-15 parts unit. It was got at years ago. Power connector is gone as are the tubes, but the book matches if you’re in fit a Tough Dog   There’s also loose wiring inside. I have a working pair already and have lots on my plate anyway.  

Anyone need all or specific parts from it? Free for the postage and a cuppa. 

Jim Falls
K6FWT 
Eureka CA

> On Sep 2, 2025, at 10:41, howard holden <holden7471 at msn.com> wrote:
> 
> 
> I have both the LM-18, which I just use with a makeshift supply, and a BC-221 (not sure which series, but it has 110V supply in it). Don't know which I prefer, perhaps the LM, they're both running fine. I use it with my GO-9 occasionally if I want to set it to an exact freq. Nice meters. Just remember they were built in WW2 (80+ years old) so they're not going to be as stable as when they were new. 
> 
> 73, Howie WB2AWQ
> From: arc5-bounces at mailman.qth.net <arc5-bounces at mailman.qth.net> on behalf of Mark K3MSB <mark.k3msb at gmail.com>
> Sent: Tuesday, September 2, 2025 8:47 AM
> To: Ken Gordon <kgordon2006 at frontier.com>
> Cc: ARC5 <arc5 at mailman.qth.net>; List Milsurplus <milsurplus at mailman.qth.net>
> Subject: Re: [ARC5] [Milsurplus] BC-221AK Question
>  
> Over the weekend I rebuilt the power supply.   It's using the original chassis and it's not going to win any prizes,  but it's providing 150V regulated voltage and 6.3 VAC now.
> 
> Added a new cord and fuse etc.   The internal wiring was horrid;  I'm surprised it didn't short the B+ at some point....    fixed that stuff.
> 
> A winter project is going to be doing a complete rebuild of the PS on a new chassis.
> 
> The audio choke in the picture I posted is obviously not 150H..... in fact at 1 Kc it measures 1H.
> 
> I have a hanger queen BC-221M and I extracted the choke from it.    Its 250 H at 1 Kc and it will have to do,
> 
> Of course, the form factor is different so I'm going to have to bolt it on.
> 
> <image.png>
> 
> 
> 73 Mark K3MSB
> 
> 
> 
> 
> 
> 
> 
> On Wed, Aug 27, 2025 at 8:34 PM Mark K3MSB <mark.k3msb at gmail.com> wrote:
> Hi Ken
> 
> >> The cap is part 9-2, not 0-2 and it is supposed to be 0.001 uF.
> 
> Yes, my typos.   Too lazy to roll over to the bench and get my glasses........     :-)
> 
> <image.png>
> 
> 
> .... and thus the motivation for my question....
> 
> <image.png>
> 
> 
> <image.png>
> 
> 
> The internal HB Power Supply was a "Widow-Maker" Special......with leaky caps!!!
> 
> I will rebuild the PS tomorrow and power it up (after dressing the connections associated with the replacement components.....and using the correct parallel capacitor.
> 
> 73 Mark K3MSB
> 
> 
> 
> 
> On Wed, Aug 27, 2025 at 7:46 PM Kenneth G. Gordon <kgordon2006 at frontier.com> wrote:
> On 27 Aug 2025 at 18:56, Mark K3MSB wrote:
> 
> > I have a BC-221 whose ID plate says  BC-221E.   It is not an E
> > variant.
> > From the tubes, front panel controls, and TM11-300,  I think it's the
> > AK variant.
> 
> I have two -AKs here: unfortunately. in storage, not in the shack. :-(
> 
> > Looking at the front panel,  what is supposed to be behind the two
> > antenna connectors?
> 
> Well, only ONE is an antenna connector: the "other" one is a ground connector...or should be.
> 
> > I tried discerning it from TM11-300.   I think it's supposed to be a
> > 150 H Choke (Part 24) in parallel
> > with a 0.01 uF cap (Part 0-2).
> 
> The cap is part 9-2, not 0-2 and it is supposed to be 0.001 uF.
> 
> >    Can anyone confirm?
> 
> Well, a 150 H choke would be physically fairly large for a "small" choke. I would have to go to my storage building and open one of my -AKs up to check, and cannot do that just now.
> 
> I hope Wayne can help. If all else fails, I'll make a run to my storage and take look as soon as I can.
> 
> BTW, the -AK version is one of only two other versons which include AF modulation capability. None of the others have that. This makes the -AK a fully functioning signal generstor.
> 
> Ken W7EKB
> ______________________________________________________________
> ARC5 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/arc5
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:ARC5 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: https://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20250902/ea36019a/attachment-0001.html>