[ARC5] BC-455-B Rcvr - removing solder from jack pins

[Richard Knoppow]

    Good suggestions, have used both successfully. For this I think the 
Solder Wick might be best, perhaps with a small dose of rosin.

On 6/2/2024 5:04 PM, mstangelo at comcast.net wrote:
> Have you tried a solder sucker with the Teflon tip that fits over the pin? How about solder wick?
> 
> Mike N2MS
> 
>> On 06/02/2024 7:37 PM EDT Matt P <mgpaulonis at gmail.com> wrote:
>>
>>
>> Since getting hooked on this SCR-264N restoration project, I've started to go a little bit beyond restoring basic functionality to original configurations. I picked up a BC-455-B receiver that had the J1 box on the front remover with a 1/4" audio jack, potentiometer, and a switch hard-wired in. Then I picked up a partial BC-455 that had J1 still on the front, but with wires soldered to all of the pins. Has anyone been successful at removing solder from these 3mm banana pins?
>>
>> Regards,
>> Matt
>> W2NS


-- 
Richard Knoppow
Los Angeles
WB6KBL
SKCC 19998