[ARC5] Radio receiver type CW-46051A

[David Stinson]

Which coils are you using?
Go from "stem to stern" and look for Hi-Z grounds.
Give them a tweak to break-up oxidation.

Look at the banana jacks that connect the coils
and the power plugs.  Is the base ring- soldered in place
holding the jack- loose?  Resoldering them can be a challenge.

Look at the tube bases for bad solder joints.  Give each pin
a small drop of De-Ox-It where the rivet holds each pin
assembly together. Then reinsert the tube and give it a gentle,
circular motion to work the De-Ox-It into the pin socket assembly.
This is a favourite place for oxidation between the parts.

If you have a dual coil, you'll need to disassemble it
and De-Ox-It the rotary contacts.  Contact me before you
start and I'll give you a step=by=step to make this easier.

Do you need more coils?  If so which ones?
I have extras that need a good home.  Postage only.

GL OM ES 73 DE Dave AB5S


On 10/18/2022 8:09 PM, J Mcvey via ARC5 wrote:
> I'm restoring this system with the original dyno, junction box, control 

-- 
This email has been checked for viruses by Avast antivirus software.
www.avast.com