[ARC5] Fwd: T23 tuning tool

[John Hutchins]

Neil =

Most likely easier said than done}

YouTube is your friend, how to mold things.....

mcmaster car has :

1. Shrink-Resistant Modeling Clay : or use paster?

2. rubber/plastic molding compounds:

3. socket head screws (brass or bronze)

It May cost ~15.00 $ bucks for each tool when all is said and done ?

Take a small handle screwdriver,  make a split Mold from it, sheet of 
paper between the two halves mold of the screwdriver handle.

Pour in the rubber/or/plastic compound, stick the socket head screw in 
the middle and VO-La ! Custom tuning tool.

Hutch



On 6/8/2019 3:21 PM, AKLDGUY . wrote:
> Hi John. I know nothing about this method of fabricating things. I 
> guess I would have to pay someone to draw up the design from my 
> instructions?
>
> Neil ZL1ANM
>
>
> On Sun, Jun 9, 2019 at 2:47 AM John Saxon <johnbsaxon at yahoo.com 
> <mailto:johnbsaxon at yahoo.com>> wrote:
>
>     This may be a bit naive, but would this lend itself to a 3d
>     printed, custom built tool?  It may very well be too small for a
>     hobby printer to print.
>
>     Just a thought,
>     John
>     K5ENQ
>
>
> ______________________________________________________________
> ARC5 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/arc5
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:ARC5 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: https://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20190608/8cbf4771/attachment.html>