[ARC5] BC-458 and 696 parts question..

[Michael Hanz]

I finally had some time to add the missing dimensions in the web link 
below, Craig.  I snagged them using the digital readout and a 20x scope 
on the Bridgeport mill, then checked them with my Starrett dial 
calipers, so they should be as close as is practical.  Not surprisingly, 
there were some minor variations of a couple of thou or three between 
evenly spaced lines, but it isn't noticeable to the unaided eye.  Good luck!

       Vy 73,
- Mike  KC4TOS

On 12/2/2019 5:30 PM, Michael Hanz wrote:
> You can get a higher resolution copy of the scan I sent you, along 
> with additional info,  by going to the web page - 
> https://aafradio.org/garajmahal/Command_set_roller_windows.html
>
> If you can wait, I'll try to get around to putting the other 
> dimensions on the image in the next couple of days.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20191206/4e066fd0/attachment.html>