[ARC5] Scott receiver

[J Mcvey]

Well, you'll never get it done in one sitting!I use the "side bench" approach. Since it's "catch as catch can " mode, I had to find a way to store it away in "standby" between re-capping sessions. Use either a rolling table to pull in to work on when you have a few moments or set it on a board or piece of cardboard to slide it off to the side when you are not working on it.This way i can dive right in instead of setting everything up and breaking it down constantly.
I like to cut the ARC-5 cap cans open with a pipe cutter and put ceramics or mylars inside, then solder them back together., so it's a bit time consuming. However, it seems to get done when I approach the project  this way.
 

    On Thursday, November 2, 2017, 8:46:35 PM EDT, Jim Haynes <jhhaynes at earthlink.net> wrote:  
 
 I recently acquired an RCH also.  Waiting to find time to deal with all
the leaky caps.

______________________________________________________________
ARC5 mailing list
Home: http://mailman.qth.net/mailman/listinfo/arc5
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:ARC5 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20171103/0888b259/attachment.html>